Coverage is approximately 12m2 per litre per coat and typically 2 coats are required.

Primer and Undercoats:

• For use on interior woodwork : Farrow & Ball Interior Wood Primer & Undercoat
• For use on metal : Farrow & Ball Metal Primer & Undercoat
• For use on interior walls & ceilings : Farrow & Ball Wall & Ceiling Primer & Undercoat

How to Apply Paint to Trim by Brush:

• Stir thoroughly before use.
• By "trim" we mean: skirting boards, picture rails, dado rails, doors, door frames and architraves, interior window sills and window frames (providing they aren't plastic).
• Farrow & Ball paints are water borne, and unlike solvent borne paints, water borne paint is more resistant to sagging and you will achieve the best finish by painting a thicker coat.
• For best results use a quality fine-tipped synthetic bristled paint brush.
• Load the brush well and apply a generous first coat.
• Brushing first in a vertical direction then in a horizontal direction until an even coating has been applied.
• Finish by 'laying off' the paint in one direction using light pressure, with the brush held at an angle of approximately 30°.
• Do not “overwork” the paint or attempt to brush it out in thin even coats as you would a traditional solvent borne paint as this may create excess brush marks.
• Allow to dry completely (for a minimum of 4 hours) before applying a second coat following the same technique as before. 

How to Apply Paint to Trim by Roller:

• This paint finish can also be applied using a Medium Pile Woven Polyester Roller.
• This will provide a good finish with minimal stippling and is a quick method of application.
• However, where an optimum finish is required, we would recommend brush application using a synthetic bristled brush.

How to Apply Paint to Walls by Brush:

• Stir thoroughly before use.
• Ensure all surfaces are sound, clean, dry and free from dirt, grease and other contamination. Please note that flaking or peeling may occur if you paint over weak paint layers - to avoid this sand back any previous weak paint layers before you start painting.
• Where required apply Farrow & Ball Wall & Ceiling Primer & Undercoat to improve paint adhesion and promote depth of colour.
• Using a fine-tipped synthetic bristled brush, apply the paint in a vertical direction then spread the paint out evenly in a horizontal direction.
• On application of the final coat lay off the paint in a single direction to ensure that any brush marks and brush patterning effects (sometimes visible in certain lighting conditions) are minimised.

How to Apply Paint to Walls by Roller:

• Stir thoroughly before use. Using a medium pile woven polyester roller, apply the paint in diagonal strokes to create either an "M", "W" or "V" shape.
• Fill in and over the shape you have just painted to spread the paint evenly. Repeat this process, working in small sections.
• Always work from dry to wet areas, maintaining a wet edge to minimise roller marks.
• On application of the final coat lay off the paint in a single direction to ensure that any roller patterning effects (sometimes visible in certain lighting conditions) are minimised. 

Clean brushes, rollers and equipment with warm soapy water.

Store in a dry place free from excessive heat or frost. Ensure lid is air tight after use.

Do not empty into drains or watercourses. Dispose of contents/container to waste disposal site in accordance with local/national regulations. Contact the local Environmental Department for disposal instructions. Metal containers may be recycled. 

• Water based paint which is quick drying
• Eco friendly
• very flat finish - 2% sheen level